XP-55 Ascender | |
---|---|
Curtiss XP-55 Ascender in flight. | |
Role | Fighter |
National origin | United States |
Manufacturer | Curtiss-Wright Corporation |
First flight | 19 July 1943 |
Status | Canceled at flight-test stage |
Number built | 3 |
The Curtiss-Wright XP-55 Ascender (company designation CW-24) is a 1940s United States prototype fighter aircraft built by Curtiss-Wright. Along with the Vultee XP-54 and Northrop XP-56, it resulted from United States Army Air Corps proposal R-40C issued on 27 November 1939 for aircraft with improved performance, armament, and pilot visibility over existing fighters; it specifically allowed for unconventional aircraft designs. An unusual design for its time, it had a canard configuration with a rear-mounted engine, and two vertical tails at end of swept wings. Because of its pusher design, it was satirically referred to as the "Ass-ender". [1] Like the XP-54, the Ascender was designed for the 1,800 hp Pratt & Whitney X-1800 24-Cylinder H-engine, but was redesigned after that engine project was canceled. It was also the first Curtiss fighter aircraft to use tricycle landing gear.
In June 1940, the Curtiss-Wright company received an Army contract for preliminary engineering data and a powered wind tunnel model. [2] The designation 'P-55' was reserved for the project. The exhaustive wind-tunnel tests that from November 1940 through January 1941 left the USAAC dissatisfied with the results of these tests. [3] [4]
Accordingly, Curtiss-Wright built at their St Louis division a flying full-scale mockup they designated CW-24B. [5] The flying testbed was powered by a 275 hp (205 kW) Menasco C68-5 inline engine. [3] [6] [ unreliable source? ] It had a fabric-covered, welded steel tube fuselage with a wooden wing. [7] The undercarriage was non-retractable. [3] The canard did not carry load but only trimmed flight. [5] The CW-24B model completed its maiden flight in December 1941. [3] From November 1941 to May 1942, the Model 24B logged 169 flights at Muroc Dry Lake, California. The tests appeared to show potential. [4] The CW-24B then went to NACA at Langley Field for wind tunnel tests. [5]
On 10 July 1942, the United States Army Air Forces issued a contract for three prototypes under the designation XP-55. [4] [6] Serial numbers 42-78845 through 42-78847 were assigned to the aircraft. During this time, the Pratt & Whitney X-1800 H-block sleeve valve engine was delayed, and was eventually canceled. [7] Curtiss decided to switch to the 1,000 hp (750 kW) Allison V-1710 [4] (F16) liquid-cooled inline engine because of its proven reliability. [7] Armament was to be two 20 mm (0.79 in) Hispano autocannon and two 0.50 in (12.7 mm) M2 Bowning heavy machine guns. [3] During the mock-up phase, engineers switched to the 1,275 hp (951 kW) V-1710-95. [4] [8] The 20mm cannons were also replaced by 0.50-in machine guns. [6]
One feature of the XP-55 was a propeller jettison lever inside the cockpit to prevent the pilot from hitting the propeller during bailout. The jettison device was invented by W. Jerome Peterson while working as a design engineer for Curtiss-Wright. [3] [7]
Three XP-55 prototypes were built. Two were destroyed during flight testing, as a result of their propensity for sudden wing stalls.
The first XP-55 (42-78845) was completed and delivered on 13 July 1943, with the same configuration as the final prototype CW-24B. The aircraft made its first flight on 19 July 1943 [3] [8] from the Army's Scott Field near the Curtiss-Wright plant in St Louis, Missouri. [7] The pilot was J. Harvey Gray, [3] Curtiss' test pilot. Testing revealed the takeoff run was excessively long. To solve this problem, the nose elevator size was increased and the aileron up-trim was interconnected with the flaps so it operated after the flaps were lowered. [7]
In 15 November 1943, test pilot Harvey Gray, flying the first XP-55 (S/N 42-78845), was testing the aircraft's stall performance at altitude. Suddenly, the XP-55 inverted into an uncontrolled descent. The engine failed "making recovery impossible" [2] and it fell out of control for 16,000 ft (4,900 m) before Gray was able to parachute to safety. The aircraft was destroyed and "left a smoking hole in the ground". [4] [7]
The second XP-55 (serial 42-78846) was similar to the first, but with a slightly larger nose-elevator, [7] modified elevator-tab systems, and a change from balance tabs to spring tabs on the ailerons. It flew for the first time on 9 January 1944. [4] [7] All flight tests were restricted so the stall-zone was avoided; included no stalling below 20,000 ft. [5] [7] [9]
The third XP-55 (serial 42-78847) flew for the first time on 25 April 1944. Modifications resulting from the investigation of the crash of the first prototype were introduced during construction; the addition of four-foot wingtip extensions to improve the stall characteristics and increasing the limits of the nose elevator travel to improve recovery if a stall did occur. [2] It was the only prototype to be fitted with armament - four 0.5-inch machine guns. [5]
After the second XP-55 (42-78846) was given the same modifications as the third prototype, it underwent official USAAF flight trials between 16 September and 2 October 1944.
The third prototype XP-55 (s/n 42-78847) was lost on 27 May 1945, during the closing day of the Seventh War Bond Air Show at the Army Air Forces Fair at Wright Field in Dayton, Ohio. [7] [10] After a low pass in formation with a Lockheed P-38 Lightning and a North American P-51 Mustang [7] on each wing, its pilot, William C. Glasgow, attempted a slow roll, [7] but lost altitude and crashed, sending flaming debris into occupied civilian ground vehicles on a highway near the airfield. The crash killed Glasgow and four civilians on the ground. [7] [11]
In test flights the XP-55 achieved 390 mph at 19,300 feet but there were engine cooling problems. [2] In terms of overall performance, testing of the XP-55 revealed it to be inferior to conventional fighter aircraft. [4] [7] [12] In addition, by the end of 1944, German and British jet-powered fighters were fully operational, and the Lockheed XP-80 was about to commence operational trials with USAAF units in Italy. Development of completely new piston-engine fighter designs was regarded as redundant; further development of such aircraft was terminated, including the XP-55.
Data from Green and Swanborough 1977 [16] [17] Air and Space Museum [18]
General characteristics
Performance
Armament
Aircraft of comparable role, configuration, and era
Related lists
The Bell P-63 Kingcobra is an American fighter aircraft that was developed by Bell Aircraft during World War II. Based on the preceding Bell P-39 Airacobra, the P-63's design incorporated suggestions from P-39 pilots and was superior to its predecessor in virtually all respects. The P-63 was not accepted for combat use by the United States Army Air Forces. However, it was used during World War II by the Soviet Air Force, which had also been the most prolific user of the P-39.
The Curtiss C-46 Commando is a low-wing, twin-engine aircraft derived from the Curtiss CW-20 pressurised high-altitude airliner design. Early press reports used the name "Condor III" but the Commando name was in use by early 1942 in company publicity. It was used primarily as a cargo aircraft during World War II, with fold-down seating for military transport and some use in delivering paratroops. Mainly deployed by the United States Army Air Forces, it also served the U.S. Navy/Marine Corps, which called it R5C. The C-46 filled similar roles as its Douglas-built counterpart, the C-47 Skytrain, with some 3,200 C-46s produced to approximately 10,200 C-47s.
The Curtiss P-36 Hawk, also known as the Curtiss Hawk Model 75, is an American-designed and built fighter aircraft of the 1930s and 40s. A contemporary of the Hawker Hurricane and Messerschmitt Bf 109, it was one of the first of a new generation of combat aircraft—a sleek monoplane design with a retractable undercarriage making extensive use of metal in its construction.
The Bell XP-77 development was initiated by the United States Army Air Forces during World War II to produce a simplified "lightweight" fighter aircraft using non-strategic materials. Despite being innovative, the diminutive prototype proved tricky to handle and the project was canceled when the XP-77 did not deliver its projected performance.
The Curtiss XP-46 was a 1940s American prototype fighter aircraft. It was a development of the Curtiss-Wright Corporation in an effort to introduce the best features found in European fighter aircraft in 1939 into a fighter aircraft which could succeed the Curtiss P-40, then in production.
The Curtiss P-60 was a 1940s American single-engine single-seat, low-wing monoplane fighter aircraft developed by the Curtiss-Wright company as a successor to their P-40. It went through a lengthy series of prototype versions, eventually evolving into a design that bore little resemblance to the P-40. None of these versions reached production.
The Curtiss XP-62 was a prototype single-engine interceptor aircraft, that was built for the United States Army Air Forces, by the Curtiss-Wright Corporation. It first flew in 1943.
The Curtiss-Wright Model 21 was an American fighter-interceptor developed by the St. Louis Airplane Division of Curtiss-Wright Corporation during the 1930s.
The Grumman XP-50 was a land-based development of the shipboard XF5F-1 Skyrocket fighter, entered into a United States Army Air Corps (USAAC) contest for a twin-engine heavy interceptor aircraft. The USAAC placed an order for a prototype on 25 November 1939, designating it XP-50, but it lost the competition to the Lockheed XP-49.
The McDonnell XP-67 "Bat" or "Moonbat" was a prototype for a twin-engine, long-range, single-seat interceptor aircraft for the United States Army Air Forces. Although the design was conceptually advanced, it was beset by numerous problems and never approached its anticipated level of performance. The project was cancelled after the sole completed prototype was destroyed by an engine fire.
The Republic XP-69 was an American fighter aircraft proposed by Republic Aviation in 1941 in response to a requirement by the United States Army Air Corps for a high-speed fighter. Manufacturers were encouraged to consider unorthodox designs; although the design was ordered as a prototype it was canceled because of delays with the engine that was to power it.
The Vultee XP-54 Swoose Goose was a prototype fighter built by the Vultee Aircraft Company for the United States Army Air Forces (USAAF).
The Northrop XP-56 Black Bullet was a unique prototype fighter interceptor built by the Northrop Corporation. It was one of the most radical of the experimental aircraft built during World War II. Ultimately, it was unsuccessful and did not enter production.
The P-1 Hawk was a 1920s open-cockpit biplane fighter aircraft of the United States Army Air Corps. An earlier variant of the same aircraft had been designated PW-8 prior to 1925.
The Consolidated P-30 (PB-2) was a 1930s United States two-seat fighter aircraft. An attack version called the A-11 was also built, along with 2 Y1P-25 prototypes and YP-27, Y1P-28, and XP-33 proposals. The P-30 is significant for being the first fighter in United States Army Air Corps service to have retractable landing gear, an enclosed and heated cockpit for the pilot, and an exhaust-driven turbo-supercharger for altitude operation.
The Boeing XP-9 was the first monoplane fighter aircraft produced by the United States aircraft manufacturing company Boeing. It incorporated sophisticated structural refinements that were influential in later Boeing designs. The sole prototype exhibited unsatisfactory characteristics with its lack of pilot visibility directly leading to its cancellation.
The Boeing Model 15 was a United States single-seat open-cockpit biplane fighter aircraft of the 1920s, manufactured by the Boeing company. The Model 15 saw service with the United States Army Air Service and with the United States Navy as a carrier-based fighter.
The SAI-Ambrosini SS.4 was an Italian fighter prototype developed in the late 1930s, featuring a canard-style wing layout and a pusher propeller. Development of the SS.4 was abandoned after the prototype crashed on its second flight.
The Curtiss-Wright CW-19 was a civil utility aircraft designed in the United States in the mid-1930s and built in small quantities in a number of variants including the CW-23 military trainer prototype.
The Curtiss P-37 was an American fighter aircraft made by Curtiss-Wright in 1937 for the US Army Air Corps. A development of the Curtiss P-36 Hawk to use an inline engine instead of the radial engine of the P-36 the fuselage was lengthened and the cockpit moved back. A small number of YP-37 aircraft was built for Air Corps evaluation. The expected top speed was not achieved and the project terminated in favor of the Curtiss P-40.