Kelvin equation
![]() | This article includes a list of general references, but it lacks sufficient corresponding inline citations. (September 2018) |
The Kelvin equation describes the change in vapour pressure due to a curved liquid–vapor interface, such as the surface of a droplet. The vapor pressure at a convex curved surface is higher than that at a flat surface. The Kelvin equation is dependent upon thermodynamic principles and does not allude to special properties of materials. It is also used for determination of pore size distribution of a porous medium using adsorption porosimetry. The equation is named in honor of William Thomson, also known as Lord Kelvin.
Formulation
[edit]The original form of the Kelvin equation, published in 1871, is: [1] where:
- = vapor pressure at a curved interface of radius
- = vapor pressure at flat interface () =
- = surface tension
- = density of vapor
- = density of liquid
- , = radii of curvature along the principal sections of the curved interface.
This may be written in the following form, known as the Ostwald–Freundlich equation: where is the actual vapour pressure, is the saturated vapour pressure when the surface is flat, is the liquid/vapor surface tension, is the molar volume of the liquid, is the universal gas constant, is the radius of the droplet, and is temperature.
Equilibrium vapor pressure depends on droplet size.
- If the curvature is convex, is positive, then
- If the curvature is concave, is negative, then
As increases, decreases towards , and the droplets grow into bulk liquid.
If the vapour is cooled, then decreases, but so does . This means increases as the liquid is cooled. and may be treated as approximately fixed, which means that the critical radius must also decrease. The further a vapour is supercooled, the smaller the critical radius becomes. Ultimately it can become as small as a few molecules, and the liquid undergoes homogeneous nucleation and growth.
![](http://upload.wikimedia.org/wikipedia/commons/thumb/1/17/Balance_of_Hydrostatic_Forces_in_a_Closed_System-en.svg/220px-Balance_of_Hydrostatic_Forces_in_a_Closed_System-en.svg.png)
The change in vapor pressure can be attributed to changes in the Laplace pressure. When the Laplace pressure rises in a droplet, the droplet tends to evaporate more easily.
When applying the Kelvin equation, two cases must be distinguished: A drop of liquid in its own vapor will result in a convex liquid surface, and a bubble of vapor in a liquid will result in a concave liquid surface.
History
[edit]The form of the Kelvin equation here is not the form in which it appeared in Lord Kelvin's article of 1871. The derivation of the form that appears in this article from Kelvin's original equation was presented by Robert von Helmholtz (son of German physicist Hermann von Helmholtz) in his dissertation of 1885.[2] In 2020, researchers found that the equation was accurate down to the 1nm scale.[3]
Derivation using the Gibbs free energy
[edit]The formal definition of the Gibbs free energy for a parcel of volume , pressure and temperature is given by:
where is the internal energy and is the entropy. The differential form of the Gibbs free energy can be given as
where is the chemical potential and is the number of moles. Suppose we have a substance which contains no impurities. Let's consider the formation of a single drop of with radius containing molecules from its pure vapor. The change in the Gibbs free energy due to this process is
where and are the Gibbs energies of the drop and vapor respectively. Suppose we have molecules in the vapor phase initially. After the formation of the drop, this number decreases to , where
Let and represent the Gibbs free energy of a molecule in the vapor and liquid phase respectively. The change in the Gibbs free energy is then:
where is the Gibbs free energy associated with an interface with radius of curvature and surface tension . The equation can be rearranged to give
Let and be the volume occupied by one molecule in the liquid phase and vapor phase respectively. If the drop is considered to be spherical, then
The number of molecules in the drop is then given by
The change in Gibbs energy is then
The differential form of the Gibbs free energy of one molecule at constant temperature and constant number of molecules can be given by:
If we assume that then
The vapor phase is also assumed to behave like an ideal gas, so
where is the Boltzmann constant. Thus, the change in the Gibbs free energy for one molecule is
where is the saturated vapor pressure of over a flat surface and is the actual vapor pressure over the liquid. Solving the integral, we have
The change in the Gibbs free energy following the formation of the drop is then
The derivative of this equation with respect to is
The maximum value occurs when the derivative equals zero. The radius corresponding to this value is:
Rearranging this equation gives the Ostwald–Freundlich form of the Kelvin equation:
Apparent paradox
[edit]An equation similar to that of Kelvin can be derived for the solubility of small particles or droplets in a liquid, by means of the connection between vapour pressure and solubility, thus the Kelvin equation also applies to solids, to slightly soluble liquids, and their solutions if the partial pressure is replaced by the solubility of the solid () (or a second liquid) at the given radius, , and by the solubility at a plane surface (). Hence small particles (like small droplets) are more soluble than larger ones. The equation would then be given by:
These results led to the problem of how new phases can ever arise from old ones. For example, if a container filled with water vapour at slightly below the saturation pressure is suddenly cooled, perhaps by adiabatic expansion, as in a cloud chamber, the vapour may become supersaturated with respect to liquid water. It is then in a metastable state, and we may expect condensation to take place. A reasonable molecular model of condensation would seem to be that two or three molecules of water vapour come together to form a tiny droplet, and that this nucleus of condensation then grows by accretion, as additional vapour molecules happen to hit it. The Kelvin equation, however, indicates that a tiny droplet like this nucleus, being only a few ångströms in diameter, would have a vapour pressure many times that of the bulk liquid. As far as tiny nuclei are concerned, the vapour would not be supersaturated at all. Such nuclei should immediately re-evaporate, and the emergence of a new phase at the equilibrium pressure, or even moderately above it should be impossible. Hence, the over-saturation must be several times higher than the normal saturation value for spontaneous nucleation to occur.
There are two ways of resolving this paradox. In the first place, we know the statistical basis of the second law of thermodynamics. In any system at equilibrium, there are always fluctuations around the equilibrium condition, and if the system contains few molecules, these fluctuations may be relatively large. There is always a chance that an appropriate fluctuation may lead to the formation of a nucleus of a new phase, even though the tiny nucleus could be called thermodynamically unstable. The chance of a fluctuation is e−ΔS/k, where ΔS is the deviation of the entropy from the equilibrium value.[4]
It is unlikely, however, that new phases often arise by this fluctuation mechanism and the resultant spontaneous nucleation. Calculations show that the chance, e−ΔS/k, is usually too small. It is more likely that tiny dust particles act as nuclei in supersaturated vapours or solutions. In the cloud chamber, it is the clusters of ions caused by a passing high-energy particle that acts as nucleation centers. Actually, vapours seem to be much less finicky than solutions about the sort of nuclei required. This is because a liquid will condense on almost any surface, but crystallization requires the presence of crystal faces of the proper kind.
For a sessile drop residing on a solid surface, the Kelvin equation is modified near the contact line, due to intermolecular interactions between the liquid drop and the solid surface. This extended Kelvin equation is given by[5]
where is the disjoining pressure that accounts for the intermolecular interactions between the sessile drop and the solid and is the Laplace pressure, accounting for the curvature-induced pressure inside the liquid drop. When the interactions are attractive in nature, the disjoining pressure, is negative. Near the contact line, the disjoining pressure dominates over the Laplace pressure, implying that the solubility, is less than . This implies that a new phase can spontaneously grow on a solid surface, even under saturation conditions.[6]
See also
[edit]References
[edit]- ^ Sir William Thomson (1871) "On the equilibrium of vapour at a curved surface of liquid," Philosophical Magazine, series 4, 42 (282) : 448-452. See equation (2) on page 450.
- ^ Robert von Helmholtz (1886) "Untersuchungen über Dämpfe und Nebel, besonders über solche von Lösungen" (Investigations of vapors and mists, especially of such things from solutions), Annalen der Physik, 263 (4): 508–543. On pages 523–525, Robert von Helmholtz converts Kelvin's equation to the form that appears here (which is actually the Ostwald–Freundlich equation).
- ^ Ouellette, Jennifer (2020-12-09). "Physicists solve 150-year-old mystery of equation governing sandcastle physics". Ars Technica. Retrieved 2021-01-25.
- ^ 1. Kramers, H. A. Brownian motion in a field of force and the diffusion model of chemical reactions. Physica 7, 284–304 (1940).
- ^ Sharma, Ashutosh (1 August 1998). "Equilibrium and Dynamics of Evaporating or Condensing Thin Fluid Domains: Thin Film Stability and Heterogeneous Nucleation". Langmuir. 14 (17): 4918. doi:10.1021/la971389f. Retrieved 15 October 2021.
- ^ Borkar, Suraj; Ramachandran, Arun (30 September 2021). "Substrate colonization by an emulsion drop prior to spreading". Nature Communications. 12 (5734): 3. Bibcode:2021NatCo..12.5734B. doi:10.1038/s41467-021-26015-2. ISSN 2041-1723. PMC 8484436. PMID 34593803.
Further reading
[edit]- W. J. Moore, Physical Chemistry, 4th ed., Prentice Hall, Englewood Cliffs, N. J., (1962) p. 734–736.
- S. J. Gregg and K. S. W. Sing, Adsorption, Surface Area and Porosity, 2nd edition, Academic Press, New York, (1982) p. 121.
- Arthur W. Adamson and Alice P. Gast, Physical Chemistry of Surfaces, 6th edition, Wiley-Blackwell (1997) p. 54.
- Butt, Hans-Jürgen, Karlheinz Graf, and Michael Kappl. "The Kelvin Equation". Physics and Chemistry of Interfaces. Weinheim: Wiley-VCH, 2006. 16–19. Print.
- Anton A. Valeev,"Simple Kelvin Equation Applicable in the Critical Point Vicinity",European Journal of Natural History, (2014), Issue 5, p. 13-14.