The Rose Canyon Fault is a right-lateral strike-slip fault that runs in a north–south direction off the coast of San Diego County, California until it comes ashore near downtown San Diego. The fault is linked to the Newport–Inglewood Fault (NIFZ) in the north and either the Agua Blanca Fault or San Miguel–Vallecitos Fault Zone in the south via en echelon step overs. Conservative estimates of the fault place the length around 30–50 km (19–31 mi), while interpretations including the NIFZ place the length at 170 km (110 mi). There are not many earthquakes associated with the fault, however a magnitude 6–6.5 may have struck on the fault in 1862. The fault runs very near to populated areas when offshore, hence there is high potential for infrequent large and damaging earthquakes.
Rose Canyon Fault | |
---|---|
Rose Canyon Fault Zone, Newport Inglewood-Rose Canyon Fault Zone, Newport Inglewood-Rose Canyon-Vallecitos-San Miguel Fault Zone, Newport Inglewood-Rose Canyon-Descanso-Agua Blanca Fault Zone | |
![]() The Rose Canyon Fault is located at the bottom right of the map | |
Etymology | Rose Canyon |
Location | Onshore and offshore San Diego |
Country | United States |
State | California |
Characteristics | |
Part of | California Continental Borderland |
Length | ~30–170 km (19–106 mi) |
Tectonics | |
Earthquakes | 1862 San Diego earthquake |
Type | Right-lateral strike-slip |
![](http://upload.wikimedia.org/wikipedia/commons/thumb/9/9c/Rose_Canyon_Fault.png/220px-Rose_Canyon_Fault.png)
Tectonic setting
editSouthern California lies along a transform boundary between the Pacific Plate and North American Plate. Faulting is taken up by three main groups of faults: the San Andreas Fault and linked faults, the Eastern California Shear Zone (ECSZ), and the California Continental Borderland (CCB). The San Andreas system and the ECSZ take up around 85% of the deformation, while the CCB accommodates the rest.[1][2] The CCB is itself split into the Inner (ICB) and Outer Continental Borderlands. The ICB takes up ~6–8 mm (0.24–0.31 in) of the plate boundary's slip, with the Rose Canyon Fault being one of the most hazardous faults in the ICB system.[1][3]
Fault characteristics
editThe right-lateral strike-slip fault extends for 30–50 km (19–31 mi) and slips at a rate of 1.1–2 mm (0.043–0.079 in)/yr.[note 1][4][7] The fault begins in the San Diego Bay, then runs through La Jolla before turning offshore. It extends north paralleling the coastline before connecting with the Newport-Inglewood Fault via short en echelon step overs, and the two faults together extend for 170 km (110 mi).[8][9]
Southern terminus
editThe southern terminus of the Rose Canyon Fault Zone has not been conclusively determined, and is considered to connect to the Descanso and Agua Blanca Faults and/or the San Miguel–Vallecitos Fault Zone.[10][11] Researchers have suggested that both of these faults may transfer slip to the Rose Canyon Fault via San Diego Bay step overs, however no clear connection has been determined.[12] Around the San Diego Bay, the fault splays out into many different strands, such as the Silver Strand and Spanish Bight faults.[13][14] Some of these splay faults come very close to the Descanso Fault, which in turn links with the Agua Blanca Fault. This leads certain researchers to consider these faults interconnected as one major fault zone, the Newport Inglewood–Rose Canyon–Descanso–Agua Blanca Fault Zone.[10][15][16] Others favor an interpretation which links the Rose Canyon to the San Miguel-Vallecitos Fault Zone, though just like with the Descanso and Agua Blanca faults, there are no visible faults connecting the two.[12] Other researchers attempting to determine which of the two faults the Rose Canyon connects to in the south provide evidence for both faults having a potential link.[17][18][19]
Seismic activity
editThe Rose Canyon Fault has little associated historic seismicity, however a magnitude 6–6.5 earthquake in 1862 is often attributed to it.[20] The shock was assigned a Modified Mercalli intensity shaking of VII (Very strong). Shaking was widespread and felt in Los Angeles (over 100 mi (160 km) away). However, due to the lack of reports in the area, it is not possible to guarantee that this earthquake occurred on the Rose Canyon Fault.[21] Trenching of the fault reveals multiple ruptures within the past 8,100 years, including a rupture that occurred between 300 years to shortly before the San Diego Mission was established.[22] Some of these historic ruptures have an estimated magnitude of 7–7.3.[23]
Future hazard
editThe Rose Canyon Fault Zone can produce large earthquakes which can be very destructive due to its proximity to major population centers in Southern California.[8] On the fault, earthquakes nearing magnitude 7 have a recurrence interval between 700±400[24] and 2,000 years.[23] Scenarios modeling a magnitude 6.9 earthquake predict peak ground acceleration will reach 0.55 g in San Diego, and 0.35 g in Tijuana. Downtown San Diego and Mission Bay will experience liquefaction, while Mt. Soledad may experience landslides. Coastal areas such as La Jolla and Point Loma may experience localized coastal bluff failures, and submarine canyons may have landslides which trigger tsunami.[25] Other studies link the Rose Canyon Fault with the Newport-Inglewood, and the combined fault zone can produce M7.3–7.4 earthquakes.[8]
Notes
editReferences
edit- ^ a b Bormann & Kent, p. 2.
- ^ Liu, Wang & Li 2010, p. 1.
- ^ Maloney et al., p. 6.
- ^ a b "Rose Canyon Fault Zone". Southern California Earthquake Center. Southern California Earthquake Center. Archived from the original on 16 July 2011. Retrieved 31 December 2023.
- ^ Rockwell 2010, p. 9.
- ^ Roquemore 1997.
- ^ Lindvall & Rockwell 1995, p. 10.
- ^ a b c Sahakian et al. 2017.
- ^ Rockwell & Singleton 2018, p. 2.
- ^ a b SONGS 2012, p. 2.
- ^ Abbott & Elliott 1979, p. 29.
- ^ a b Maloney et al., p. 7.
- ^ Rockwell & Singleton 2018, p. 4.
- ^ Lindvall & Rockwell 1995, p. 1.
- ^ Rockwell & Singleton 2018, p. 3-4.
- ^ Grant & Rockwell 2002.
- ^ Abbott & Elliott 1979, p. 41.
- ^ Anderson, Rockwell & Agnew 1989, p. 10.
- ^ Roquemore 1997, p. 12.
- ^ De Wyze 2000, p. 6.
- ^ Roquemore 1997, p. 8.
- ^ Lindvall & Rockwell 1995, p. 9.
- ^ a b De Wyze 2000, p. 5.
- ^ Lin II 2020.
- ^ EERI 2020, p. 34.
Sources
- Abbott, Patrick L.; Elliott, William J. (November 1979). "Faulting offshore San Diego and northern Baja California". In Legg, Mark R.; Kennedy, Michael P. (eds.). Earthquakes and other perils—San Diego region (PDF). San Diego Association of Geologists Guidebook. Retrieved 31 December 2023.
- Anderson, John G.; Rockwell, Thomas K.; Agnew, Duncan Carr (May 1989). "Past and Possible Future Earthquakes of Significance to the San Diego Region". Earthquake Spectra. 5 (2): 299–335. doi:10.1193/1.1585524. Retrieved 1 January 2024.
- Bormann, Jayne; Kent, Graham. Investigating recent deformation along the southern San Pedro Basin fault to assess evidence for connectivity between the San Pedro Basin and San Diego Trough fault systems (PDF) (Report). U.S. Geological Survey. Retrieved 27 December 2023.
- De Wyze, Jeannete (2 March 2000). "Earthquake San Diego Danger Zones" (PDF). San Diego Reader. Retrieved 1 January 2024.
- EERI (2020). San Diego Earthquake Planning Scenario (PDF) (Report). Retrieved 1 January 2024.
- Grant, Lisa B.; Rockwell, Thomas K. (2002). "A Northward-propagating Earthquake Sequence in Coastal Southern California?". Seismological Research Letters. 73 (4). doi:10.1785/GSSRL.73.4.461. Retrieved 1 January 2024.
- Lin II, Rong-Gong (4 March 2020). "San Diego faces critical earthquake danger from fault long believed to be inactive". LA Times. Retrieved 1 January 2024.
- Lindvall, Scott C.; Rockwell, Thomas K. (10 December 1995). "Holocene activity of the Rose Canyon fault zone in San Diego, California". Journal of Geophysical Research: Solid Earth. 100 (B12): 24121–24132. doi:10.1029/95JB02627. Retrieved 31 December 2023.
- Liu, Mian; Wang, Hui; Li, Qingsong (7 July 2010). "Inception of the eastern California shear zone and evolution of the Pacific-North American plate boundary: From kinematics to geodynamics". Journal of Geophysical Research. 115 (B7). Bibcode:2010JGRB..115.7401L. doi:10.1029/2009JB007055. Retrieved 30 December 2023.
- Maloney, Jillian M.; Legg, Mark; Nicholson, Craig; Rockwell, Thomas K. "White Paper: The California continental borderland" (PDF). Southern California Earthquake Center. Retrieved 30 December 2023.
- Rockwell, Thomas K.; Singleton, Drake (April 2018). Mid to Late Holocene Rupture History of the Rose Canyon Fault in San Diego, California (PDF) (Report). Retrieved 30 December 2023.
- Rockwell, Thomas K. (28 May 2010). The Rose Canyon Fault Zone in San Diego. International Conferences on Recent Advances in Geotechnical Earthquake Engineering and Soil Dynamics. Retrieved 31 December 2023.
- Roquemore, Glenn (1 April 1997). The Seismic Risk in the San Diego Region: Special Focus on the Rose Canyon Fault Systems: Workshop Proceedings. DIANE Publishing. ISBN 978-0-7881-4262-8.
- Sahakian, Valerie; Bormann, Jayne; Driscoll, Neal; Harding, Alistair; Kent, Graham; Wesnousky, Steve (7 March 2017). "Seismic constraints on the architecture of the Newport-Inglewood/Rose Canyon fault: Implications for the length and magnitude of future earthquake ruptures". Journal of Geophysical Research: Solid Earth. 122: 2085–2105. doi:10.1002/2016JB013467. Retrieved 1 January 2024.
- SONGS (December 2012). Paleoseismic Assessment of the Late Holocene Rupture History of the Rose Canyon Fault in San Diego (PDF) (Report). San Onofre Nuclear Generating Station. Archived from the original (PDF) on 15 September 2017. Retrieved 31 December 2023.
Further reading
edit- Kennedy, Michael P. (1975). Geology of the San Diego metropolitan area, California. California Division of Mines and Geology.