The .38 rimfire / 9.5x22mmRF refers to a family of cartridges that have been in service in the United States since the mid-19th century. The cartridges are produced in short, long, and extra long variants.

.38 Long rimfire
TypeRifle and handgun
Place of originUnited States
Service history
Used byUS Army
Production history
VariantsShort, Long, and Extra Long
Specifications
Case typeRimmed, straight
Bullet diameter.374 in (9.5 mm)
Neck diameter.376 in (9.6 mm)
Shoulder diameter.376 in (9.6 mm)
Base diameter.378 in (9.6 mm)
Rim diameter.433 in (11.0 mm)
Rim thickness.051 in (1.3 mm)
Case length0.874 in (22.2 mm)
Overall length1.382 in (35.1 mm)
Primer typeRimfire
Maximum pressure (CIP)13,000 psi (90 MPa)
Ballistic performance
Bullet mass/type Velocity Energy
150 gr (10 g) LRN 980 ft/s (300 m/s) 320 ft⋅lbf (430 J)
Test barrel length: Rifle
.38 Extra Long rimfire [1]
TypeRifle and handgun
Place of originUnited States
Specifications
Case typeRimmed, straight
Bullet diameter.374 in (9.5 mm)
Neck diameter.376 in (9.6 mm)
Shoulder diameter.376 in (9.6 mm)
Base diameter.378 in (9.6 mm)
Rim diameter.433 in (11.0 mm)
Rim thickness.051 in (1.3 mm)
Case length1.48 in (38 mm)
Overall length2.025 in (51.4 mm)
Primer typeRimfire
Ballistic performance
Bullet mass/type Velocity Energy
150 gr (10 g) LRN 1,250 ft/s (380 m/s) 520 ft⋅lbf (710 J)
Test barrel length: Rifle

Much like the smaller .32 rimfire, the rounds were originally manufactured loaded with black powder. In the early 1900s, manufacturers switched to the "new" smokeless powder.

The .38 rimfire was preferred to the .32 rimfire for hunting and self-defense purposes because of its larger diameter bullet and increased muzzle energy.

History

edit

The .38 rimfire cartridge was a common round for many antique revolvers and rifles from the 1870s to the early 1900s. It was a common self-defense round for a small revolver that was often kept in a vest pocket through to the 1890s. Production in the United States of rimfire calibers larger than .22 ceased upon the country's entry into World War II and was never resumed again by any of the major manufacturers. Factory loaded ammunition is no longer available except as collector items.

Uses and variants

edit

The .38 rimfire cartridge was available in short, long, extra long, and also shotshells. Most of the revolvers and rifle which were produced were chambered for either .38 short rifle, or .38 long rifle. While there were a few different rifles produced for the .38 extra long cartridge and a few rolling block, falling block, and bolt-action rifles had smoothbore barrels which had a slight choke which enabled it to shoot the .38 RF shotshells, which was good for hunting small game at close ranges. Hopkins & Allen produced revolvers and rifles chambered for the .38RF. Rifles of this caliber were produced by Remington (the revolving rifle of 1866), Ballard, Stevens and Frank Wesson, and revolvers by Enterprise, Favorite, Forehand & Wadsworth, and Colt.[2]

See also

edit

References

edit
  1. ^ Barnes, Frank C. (2012). Richard A. Mann (ed.). Cartridges of the World (13th ed.). p. 0. ISBN 978-1-4402-3059-2.
  2. ^ Barnes, Frank C. (2012). Richard A. Mann (ed.). Cartridges of the World A Complete Illustrated Reference for over 1500 Cartridges. Gun Digest. p. 500. ISBN 978-1-4402-3059-2.