CENTEC

This study presents a practical optimization procedure that couples the NavCad power prediction tool and a nonlinear optimizer integrated into the Matlab environment. This developed model aims at selecting a propeller at the engine operating point with minimum fuel consumption for different ship speeds in calm water condition. The procedure takes into account both the efficiency of the propeller and the specific fuel consumption of the engine. It is focused on reducing fuel consumption for the expected operational profile of the ship, contributing to energy efficiency in a complementary way as ship routing does. This model assists the ship and propeller designers in selecting the main parameters of the geometry, the operating point of a fixed-pitch propeller from Wageningen B-series and to define the gearbox ratio by minimizing the fuel consumption of a container ship, rather than only maximizing the propeller efficiency. Optimized results of the performance of several marine propel...

Optimization procedures are required to minimize the amount of fuel consumption and exhaust emissions from marine engines. This study discusses the procedures to optimize the performance of any marine engine implemented in a 0D/1D numerical model in order to achieve lower values of exhaust emissions. From that point, an extension of previous simulation researches is presented to calculate the amount of SOx emissions from two marine diesel engines along their load diagrams based on the percentage of sulfur in the marine fuel used. The variations of SOx emissions are computed in g/kW·h and in parts per million (ppm) as functions of the optimized parameters: brake specific fuel consumption and the amount of air-fuel ratio respectively. Then, a surrogate model-based response surface methodology is used to generate polynomial equations to estimate the amount of SOx emissions as functions of engine speed and load. These developed non-dimensional equations can be further used directly to a...

An engine optimization model is developed to fit the calculated in-cylinder pressure diagram to the experimental data by finding the optimal values of the start angle of injection and the amount of injected fuel for different engine loads. Firstly, the engine model is built in Ricardo Wave software and some parts are calibrated using data collected from the manufacturer. Then, an optimization process is performed based on the fitness function that includes the objective of the study and the penalty functions to express constraints. This optimization environment simulates the performance of a marine generator system for three different loads by minimizing the mean absolute percentage error (MAPE) between the in-cylinder pressure simulated data and the measured data along 40 degrees of the combustion process and by verifying the firing pressure and the engine brake power. The percentage of error between the calculated and the real thermodynamic data does not exceed 3.4% and the MAPE b...