Tractors around the world operate with lubricants that have undergone development testing by SwRI. Testing is conducted on John Deere, New Holland and CASE tractors. SwRI performs a wide variety of both standardized and specialty fluid laboratory testing.
Tractor Hydraulic Fluid Testing
John Deere J20 specifications for tractor hydraulic fluid require satisfactory performance of lubricants in tests that simulate severe duty of farm tractor and industrial equipment components.
JDQ-84 Dynamic Corrosion Sauer-Danfoss Pump Test
This test screens fluids that cause corrosion of copper-containing metals in high-pressure pumps. A Sauer-Danfoss 90 Series axial piston pump is operated for 25 hours at 3,000 psi. Water is then added to the test fluid over the course of one hour. The output pressure of the pump is increased to 5,500 psi and maintained at that pressure for another 199 hours.
JDQ-94 Powershift Transmission Clutch Friction Test
This test assesses the effects of tractor hydraulic fluids on wet clutch capacity, dynamic friction coefficient, and clutch disc wear. A 200 hp John Deere engine drives a modified John Deere 4850 15-speed powershift transmission, loaded by an eddy current dynamometer. A typical test cycle consists of eight seconds of slipping the clutch at high dynamometer load and engine power. At the end of the test, three engine stall tests are performed.
JDQ-102A Shear Stability
Formerly known as JDQ-102 Shear Stability, this test determines the shear stable viscosity of a tractor hydraulic fluid. Using a diesel injection pump and 6 fuel injectors for a John Deere 6466 engine, the fluid is circulated under high pressure through the fine orifices of the injectors. This test is also used to prepare a fluid for the JDQ-95 spiral bevel/final drive wear test.
JDQ-95 Spiral Bevel/Final Drive Wear Test
This 50-hour test evaluates how effectively tractor hydraulic fluids protect the spiral bevel gears from scoring and the final drive planetary reduction gears from surface distress and wear. A John Deere engine and powershift transmission drives an industrial axle housing the test gears. A pair of high torque dynamometers provide load.
JDQ-96B Torque Variation and Brake Friction Retention Test
A John Deere 1400 series industrial axle equipped with annular wet disk brakes is used for the test axle. The brake chatter test consists of 30,000 brake engagements. After 1,000, 10,000, 20,000 and 30,000 brake engagements, a series of brake chatter tests are performed at different wheel speeds, brake pressures and temperatures.
JDQ-102B Shear Stability
Formally known as John Deere Hydraulic Pump Shear Stability, this 48-hour test uses a Sauer-Danfoss 90 series axial piston pump to circulate fluid across a hydraulic relief valve to determine the shear stable viscosity of a tractor hydraulic fluid.
Tractor Fluids Specification Testing
Specifications for tractor hydraulic fluids require satisfactory performance in gear wear protection, independent power take off (IPTO) and powershift clutch capacity, and brake chatter protection.
In addition to tractor hydraulic fluid testing, SwRI provides hydraulic fluid testing to determine the anti wear properties of hydraulic fluids.
Tractor Field Tests
SwRI provides tractor field tests on a wide range of tractors including John Deere, New Holland and CASE.
Custom Tractor Testing
In addition to standardized tractor test specifications, SwRI performs bespoke tractor testing, or custom tractor testing, including: drive cycle testing utilizing high torque dynamometers, cold weather simulations utilizing our large cold chamber, and much more. Custom test plans can be devised and quoted on request.
For questions about this testing, please contact Jim McCord at +1 210 522 3439.