How Much Does It Cost to Relocate Washer and Dryer Hookups? [2024 Data]

Washer and Dryer Hookups Relocation Cost Breakdown

The cost of relocating washer and dryer hookups entails adding several plumbing features, a dryer vent, and electrical outlets. If you’re bringing in a gas-powered dryer, you should factor in the cost to run gas lines as well. You’ll need to consider these expenses in addition to installing the machines themselves. 

Installing a Washing Machine Cut-Off Valve

A cut-off valve is necessary to stop the water supply for your washing machine. Your washing machine cut-off valve will likely cost around $10 to $30 for each line.

Building a Drain Line for the Washer

Relocating your washing machine gets trickier when plumbing costs are involved. And one major plumbing cost to relocate your washer and dryer is building a drain line. Depending on how close it is to the existing plumbing, that price could be anywhere between $360 and $1,840.

If you try to tackle this work yourself and make a mistake, you’ll need to get a plumber in pronto. However, costs will be significantly more expensive. Emergency plumbing costs up to three times as much as typical plumbing costs.

Installing Electrical Outlets and Circuits

Your washer should run on a regular 120v outlet, while dryers need high-powered outlets (~240 volts) to receive the correct power supply. The cost to install a new outlet is around $300 if you need a new outlet for the washer, and about $500 if you need a 240-volt plug for the dryer. (The type of dryer plug on your unit will impact electrical costs.) You also may need to cap an existing gas line, which costs around $125.

Running a Gas Line (Gas Dryers Only)

If you’re installing a gas dryer, you’ll need to factor in the cost to run gas lines to your new laundry room. Prices vary, but the cost for a new gas line typically falls between $200 to $5,000 or more based on how far you run the lines. Expect to pay around $20 per linear foot.

Dryer Vent Installation

Dryers need a place to push out that hot air, so don’t forget to consider installing a dryer vent. A new dryer vent costs an average of $100, but can go up to $1,000 depending on how long of a vent is needed.

Repairing Drywall

After you finish installing new hookups, you’ll likely have some minor drywall repair needs. Minor drywall repair can cost as low as $100, and your plumber or electrician may even add this to part of their labor cost. Sometimes when moving your washer and dryer, you’ll uncover mold or water damage that needs further attention. In these cases, it’s best to call a mold remediation pro to test and suggest the best course of action.

Installing the New Machines

Once you’ve set up everything, you’ll have to think about installing the units themselves. If you’re buying new units, many will include installation in the cost. If that’s not the case, you can find an appliance installation service near you and get it done for about $50 to $175 per unit. 

Cost to Relocate Washer and Dryer Hookups by Project Type

Different parts of your home have easier access to plumbing and other utilities, so the cost to move your washer and dryer upstairs will be different from the cost to move them to your garage. Below are a few common choices and their associated costs.

Moving to Another Wall or Room

The most common project involves shifting your washer and dryer to a new wall in the same room or a new room on the same floor. In these cases, you’re likely utilizing existing plumbing and electrical and possibly only adding new venting or extending the existing pipes. Expect to pay on the lower end of the cost range, closer to $1,000 to $1,500, depending on the existing connections available.

Cost to Move Washer and Dryer Upstairs

Moving your washer and dryer upstairs will likely require extending pipes, installing new faucets, and installing a longer drain line. Depending on your setup, you might pay upward of $15,000 to make this happen. A large part of this is due to the cost of installing new washer and dryer hookups.

Cost to Move Washer and Dryer to Garage or Basement

The cost to move your washer and dryer to the garage or basement is usually between $1,060 and $4,475. This covers installing the hookups, putting in a new drain line, installing a dryer vent, and adding an outlet. If you need to undertake more construction work, such as redoing the flooring or tiling the walls, you might pay anywhere between $2,000 to $15,000.

Relocating a Washer and Dryer Yourself vs. Hiring a Pro

Photo: Erik Isakson / Tetra images / Getty Images

Unless you have proper training, you should get in touch with a professional plumber near you to help you set up the necessary plumbing. Otherwise, you risk catastrophic leaks and a washing machine that won’t cycle correctly (or at all).

The same goes for adding in the proper electrical work. Your plumber may do this, or you will need to phone a local electrician to take care of it. Either way, don’t take matters into your own hands, as you’ll run into electrical dangers that could put your safety or appliances at risk. Especially in a room that sees a lot of water and high heat, the potential risks of electrical shock, water damage, and house fires are high as a result of improper installation.